Samsung VP-D361i Service Manual page 14

Alignment and Adjustments
[STEP 2]
ΠPress and hold the "STOP" and "PB ZOOM" buttons on the video camera at the same time for more than
5 seconds.
´ When monitor OSD appears as shown Fig. 3-2, the adjustment mode has been activated successfully.
ˇ Move the "ZOOM Lever" to highlight VCR ADJ and push the "PHOTO Button".
¨ Monitor OSD shows Fig. 3-3.
Then VCR adjustment mode has been activated successfully.
[STEP 3]
In order to complete the adjustment the power must be reset.
This can be done by disconnecting and reconnecting the power source.
3-1-2 VCR Adjustment
Note : This is the only electronic adjustment for the VCR.
Other addresses have already been assigned data during the manufacturing process.
We don't need any adjustment for those addresses.
Mode(Address)
858 SWP Position
ΠGet into VCR ADJUST mode.
´ Move to the VCR ADJUST address "858".
ˇ Play standard tape, and "Head Switching Position" will be adjusted automatically (within 5 Seconds).
3-2
Player Mode
Back
VCR ADJ
CAM ADJ
CAM DISP
LCDCVF AJD
DSP WRITE
VCRADJ
EPR EVR
800 OO OO
B:00000 R:00000
BER:0.0E+00
1394:OFF
AVIN:OFF
Name Value
Fig. 3-2
Fig. 3-3
<Table 3-2>
Description
80 Head Switching Position Adjust
Indicates current adjustment item
Stored value
Adjustment value
For Engineering Mode
Samsung Electronics