Intended Use; Technical Data - Bosch GHP 5-13 C Original Instructions Manual

OBJ_BUCH-1751-002.book Page 14 Tuesday, November 22, 2016 9:19 AM
14 | English

Intended Use

The product is intended for cleaning areas and objects out-
side the house, tools, vehicles and boats, if the appropriate
accessories such as cleaning agents approved by Bosch are
used.
Intended use is related to operation within 0°C and 40°C am-
bient temperature.

Technical Data

Pressure washer
Article number
Rated power
Supply temperature max.
Supply rate min.
Rated pressure
Max. operating pressure
Rated Flow
Maximum inlet pressure
Kickback force at the gun to
the maximum pressure
Motor insulation
Motor protection
Detergent tank
Autostop function
Net impedance
Weight according to EPTA-
Procedure 01:2014
Protection class
Serial number
The values given are valid for a nominal voltage [U] of 230 V. For differ-
ent voltages and models for specific countries, these values can vary.
Starting cycles generate brief voltage drops. Interference with other
equipment/machines may occur in case of unfavourable mains system
conditions. Malfunctions are not to be expected for system impedances
below 0.153 ohm.
Noise/Vibration Information
Sound emission values determined according to
EN 60335-2-79.
Typically the A-weighted noise levels of the product are:
Sound pressure level 81,8 dB(A); sound power level
90 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60335-2-79:
2 2
a =3.12 m/s , K=1.5 m/s .
h
1 609 92A 3EP | (22.11.16)
Mounting and Operation
Action
Delivery Scope
Insert dip stick for ventilation
Connect detergent bottle
Connecting to the water supply
Clean the water filter
Connecting high pressure water
supply hose/nozzle
GHP 5-13 C
Adjust water pressure
3 600 J10 0..
Adjust water jet
kW 2.3
Switching On and Off
°C 50
Working Advice
l/min 8.3
Clean nozzle
MPa 13
Starting
MPa 14
l/min 8.3
For Your Safety
MPa 1
N 22.11
Class F
Your pressure washer requires an earth connection. The op-
IPX5
erating voltage is 230 V AC, 50 Hz (for non-EU countries
–
220 V, 240 V as applicable). Only use approved extension ca-

bles. Contact your Bosch Service Centre for details.
Ω
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
kg 16.5
should be used:
/I
- 2.5 mm
- 4.0 mm
See serial number (rating
plate) on pressure washer.
Note: If an extension cable is used it must be earthed and con-
nected through the plug to the earth cable of your supply net-
work in accordance with prescribed safety regulations.
If in doubt contact a qualified electrician or the nearest Bosch
Service Centre.
Cable connections should be kept dry and off the ground.
For increased electrical safety use a Residual Current Device
(RCD) with a tripping current of not more than 30 mA. Always
check your RCD every time you use it.
If the supply cable on the product is damaged, it must only be
replaced by a Bosch Service Centre.
Products sold in GB only: Your product is fitted with an
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an author-
ised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
Figure
1
2
3
4
5
6
7
8
9
10
11
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
2
– max length 20 m
2
– max length 50 m
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
et must be of watertight construction and in-
tended for outdoor use.
Page
221
221
222
222
222
223
223
224
224
225
225
Bosch Power Tools