Troubleshooting - Philips AJ3230 User Manual

2 Press /REPEAT ALARM. Wait 1 second. If the radio is still on, press
SLEEP OFF
RADIO .
/
ON OFF

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
Problem
– Possible Cause
• Remedy
SLEEP does not function
– Radio already in the ON position
• Switch off the radio first, before setting SLEEP
Occasional crackling sound during FM broadcast
– Weak signal
• Extend and position the pigtail
Continuous crackling/hiss disturbance during MW (AM/LW) broadcast
– Electrical interference from TV, computer, fluorescent lamp, etc.
• Move set away from other electrical equipment
The alarm does not function
– Alarm time not set and/or alarm mode not selected
• See the alarm time and / select alarm mode
– Volume too low for RADIO
• Adjust the volume
– Radio alarm not adjusted to radio station
• Tune to a radio station
A
s
Y
b
i
C