Related Manuals for Philips AJ3231/79
Summary of Contents for Philips AJ3231/79
- Page 1 AJ3231 Clock Radio Register your product and get support at www.philips.com/welcome User manual...
- Page 2 &...
- Page 3 Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. CONTROLS 1 ALARM 1, ALARM 2 – RADIO activates the radio for alarm 1 or alarm 2 – BUZ activates the buzzer for alarm 1 or alarm 2 –...
-
Page 4: Illumination Brightness
INSTALLATION POWER SUPPLY 1 Check if the mains supply, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not, consult your dealer or service centre. 2 Connect the mains lead to the wall socket. 3 To disconnect the set from the mains supply completely, remove the plug from the wall socket. - Page 5 RADIO You can use this set solely as a radio! 1 Adjust RADIO ON/OFF to ON to switch on the radio. 2 Select your waveband by adjusting the BAND switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO ON/OFF to OFF to switch off the radio.
-
Page 6: Switching Off The Alarm
SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day:... -
Page 7: Connecting An External Device
IMPORTANT! 1 During SLEEP activation, if you attempt to cancel SLEEP by pressing RADIO ON/OFF, the radio cannot be switched off. 2 To switch off, press RADIO ON/OFF and REPEAT ALARM (SLEEP OFF) alternate- ly and repeatedly. CONNECTING AN EXTERNAL DEVICE You can listen to the sound of the connected external device through your AJ3231’s speakers. -
Page 8: Safety Information
SAFETY INFORMATION • Install the unit near the AC outlet and where the AC plug can be easily reached. • Where the MAINS plug is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. •... -
Page 9: Troubleshooting
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. - Page 10 This Manufacturers Warranty is limited to 3 months for products used in commercial applications. g. Product accessories are covered by the same warranty period. If an accessory is faulty, please contact the Philips Technology Care Centre on 1300 363 391.
- Page 12 Meet Philips at the Internet http://www.philips.com © 2010 Koninklijke Philips Electronics N.V. All rights reserved. AJ3231_79_UM_V4.0...