Channel Selection; Roger Beep Tone - Audiovox GMRS121-2 Owner's Manual

Channel Selection

In order to communicate with other GMRS/FRS units, both the transmit-
ting and receiving party must be on the same frequency.
The GMRS121-2 has 22 channels (frequencies) indicated by the large
digits on the LCD display panel. Channels 1 through 7 are the shared
GMRS/FRS channels. Channels 8-14 are FRS only channels, while chan-
nels 15-22 are assigned GMRS only channels. Communication with
Audiovox GMRS/FRS and compatible units is possible on these 22 chan-
nels. Before transmitting on the selected channel, check the activity on that
channel. If there is activity on the selected channel (
change to another channel that is clear.
To change the channel:
- From GMRS/FRS standby mode, press the MODE button (8) once;
the channel number flashes.
- Press the Up Button (6) briefly to move to the next higher main chan-
nel number.
- Press the Down Button (7) briefly to move to the next lower main
channel number.
- Press the PTT button momentarily to confirm selection.

Roger Beep Tone

The Roger Beep is a tone which is automatically transmitted whenever the
PTT button is released and the tone is enabled. This tone alerts the
receiving party that the transmission has been terminated intentionally.
To enable and disable the Roger Beep tone:
- From GMRS/FRS standby mode, press the MODE Button 2 times
until the flashing Roger Beep icon (
- Press the Up or Down Button to select the tone on or off as desired.
- When enabled, the tone icon (
- Press the PTT button momentarily to confirm selection.
icon is displayed),
) appears with on or oF.
) appears steady on the display.
11
128-7005
11 of 20