Resetting The Lamp Timer - Sharp XV-Z100 User Manual

Regarding the Lamp (Continued)
4
Remove the lamp unit.
• Loosen the securing screws from the
lamp unit. Hold the lamp unit by the
handle and pull it in the direction of the
arrow. At this time, keep the lamp unit
horizontal and do not tilt it.
5
Insert the new lamp unit.
• Press the lamp unit firmly into the lamp
unit compartment. Fasten the securing
screws.
6
Replace the lamp unit cover.
• Align the tab on the lamp unit cover
(1)and place it while pressing the tab
(2) to close it. Then tighten the user ser-
vice screw to secure the lamp unit cover.
• If the lamp unit and lamp unit cover are
not correctly installed, the power will not
turn on, even if the power cord is con-
nected to the projector.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.
input signals are found, the pro-
Info
the input source in the order of
• Make sure to reset the lamp timer only when
NPUT 2 INPUT 3
replacing the lamp. If you reset the lamp timer
ss INPUT (P /R ) on the projector.
and continue to use the same lamp, this may
Search " is set to " O n " , press
cause the lamp to become damaged or ex-
,C INPUT 2, D INPUT 3 or
plode.
on the remote control to select
e other than the input mode se-
projector.
1
Connect the power cord.
• Plug the power cord into the AC socket
Sync (Auto Sync
of the projector.
stment)
2
Reset the lamp timer.
ms Description
• While simultaneously holding down
UMENU/HELP, TENTER and R on the
Auto Sync adjustment will
occur when the projector is
projector, press SSTANDBY/ON on the
turned on or when the input
projector.
signals are switched, when
• "LAMP 0000H" is displayed, indicating
connected to a computer.
that the lamp timer is reset.
Auto Sync adjustment is not Downloaded from ProjectorsManual.com Manuals
52
automatically performed.
Info
3 3 3 3 3 Auto Power Off
Function
Selectable
items
On
Off
INPUT 4
Note
• When the Auto Power Off function is set to
" O n " , 5 minutes before the projector enters
standby mode, the message " E nter STANDBY
mode in X min. " will appear on the screen to
indicate the remaining minutes.
Securing screws
Menu operation
Description
When no input signal is detected for
more than 15 minutes, the projector will
automatically enter standby mode.
The Auto Power Off function will be
disabled.
AC socket
Handle
Page 39
2
1
STANDBY/ON
button
ENTER button
MENU/HELP
button
R button