Installer Mode - Salus RT310RF Installation Manual

Installer Mode

Press and hold and
The first setting is temperature display resolution selection - d01. Press
The setting will start flashing. Press
to confirm, then enter d02 (if you didn't press
seconds and the thermostat will return to normal mode). d02 is to set temperature offset, press
increase/decrease offset. To exit Installer Mode don't press any key for 10 seconds, or press
See the table below.
3 Sec
Press the three buttons
together for 3 seconds.
2
TESTING/PAIRING
dxx Function
d01 Temperature display
increments
d02 Temperature offset
d03 Frost setpoint
and keys to enter installation setting.
or
3 Sec
RESET
3 Sec
Enter first d01 setting. Press
Continue adjusting the d02 and d03 following the same steps as above.
Once you have finished setting up all the parameters, press
to home screen, or don't press any button for 10 seconds and it will
exit automatically.
Parameter
0.1°C or
0.5°C
+/-3.0°C
5.0°C-17.0°C
to change temperature display resolution, wait for 10 seconds
to save your selection, the change will be confirmed after 10
TESTING/PAIRING
Description
Select the temperature display
increments
Calibrate your thermostat tempera-
ture
Set the Frost Point temperature
to enter the existing setting.
or
5
Select increment. Press
Default
value
0.5°C
0.0°C
5.0°C
RT310RF Installation Manual
to
RESET
to exit
09