Mac-Based Access Control Port Setting - D-Link xStack DES-3800 Series User Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch

MAC-Based Access Control Port Setting

Use the following window to configure ports to be enabled or disabled for the MAC-Based Access Control feature of the Switch.
Remember, ports enabled for certain other features, listed previously (#5 Notes About MAC-Based Access Control) cannot be
enabled for MAC-Based Access Control. To view this window, open the Security folder, then the MAC-Based Access Control
folder and click the MAC-Based Access Control Port Setting link.
Figure 11- 6 . MAC-Based Access Control Port Setting and State Table 0
To configure a port or range of ports for the MAC-Based Access Control feature, use the From and To pull-down menus to
choose the ports, and then use the State pull-down menu to enable them. To view the MAC address authentication on a port-by-
port basis, click the hyperlinked port number, which will display the following window listing that pertinent information, as seen
below.
Figure 11- 6 . MAC-Based Authentication port 1 Status Table 1
249