McCulloch Li 40CS Operator's Manual page 11

the finished cut by under bucking the lower 2/3 to
meet the first cut.
• When bucking on a slope, always stand on the
uphill side of the log. When cutting through, to
maintain complete control, release the cutting
pressure near the end of the cut without relaxing
your grip on the chainsaw handles.
Do not let the saw chain contact the ground. After
completing the cut, wait for the saw chain to stop before
you move the chainsaw. Always stop the motor before
moving from tree to tree.
Cut from top (over buck) avoid cutting earth
Log supported along the entire length
Log supported both ends
WORKING TECHNIQUES
Over buck
Under buck
Log supported one end
Over buck
Under buck
Bucking a log
Stand on uphill side when cutting because log may roll
(Original Language)English - 11