Status Message - Kenwood NX-200 Instruction Manual

• Select "ALL" Fleet and "ALL" ID to make a call to all units
(Broadcast call).

STATUS MESSAGE

You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to 16
alphanumeric characters. Status messages range from 10 to
99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status
messages and short messages) can be stored in the stack
memory of your transceiver.
■ Transmitting (NX-200/ NX-300/ NX-200G/ NX-300G Only)
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
mode (proceed to step 5) or Selcall + Status to enter
Selcall mode (proceed to step 3).
3 Press
• If Manual Dialing is enabled, you can enter a station ID
by using the DTMF keypad, or by using
using
then press
right. Repeat this process until the entire ID is entered.
4 Press
5 Press
• If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using
step 3, above).
6 Press the PTT switch or Side 2 key to initiate the call.
• "<COMPLETE>" appears on the display when the status
has been successfully transmitted.
■ Receiving
A calling ID or text message will appear when a Status call
is received (NX-200/ NX-300/ NX-200G/ NX-300G Only).
Press any key to return to normal operation.
/ to select the station you want to call.
/
, cycle through the digits to select a digit,
to set the digit and move the cursor to the
to enter Status mode.
/ to select the status you want to transmit.
/
. When
/
(refer to
21