4-2. Starting up the BACnet
Double-click the BACnet
shown in the figure on the left below.
Select [New Settings] from [File] in the menu bar or select [Acquire Settings] from [AE-200/AE-50/EW-50] in the
menu bar to display the screen shown in the figure on the right below.
If [Acquire Settings] is selected when the BACnet
when a connection is not established, a communication error pop-up screen as shown below appears after
approximately 30 seconds.
If a communication error occurs, check the following.
• Is the AE-200 running (about 10 minutes is required to complete the start-up process of AE-200)?
• Is the cable between the PC and AE-200 (LAN1) connected correctly?
• Is the IP address of the PC set to an IP address of the same network as LAN1 of the AE-200? (Refer to 2-1
"Setting the IP address of the PC" for details.)
• Does the destination IP address setting of the BACnet
AE-200? (Refer to 7-2-1 "Property" for details.)
WT07921X01
®
Setting Tool
®
Setting Tool icon (AE-200_SetBACnet_v****) to start up the BACnet
®
Setting Tool (PC) is not connected with the AE-200 unit or
®
Setting Tool match the IP address of LAN1 of the
15
®
Setting Tool