Chamberlain 5580TX Instructions Manual page 23

21
Assemble Door Arm and Set Limits
NOTE: For one-piece doors, do not connect door arm to trolley
before adjusting limits. Failure to follow instructions may result in
damage to door. See below.
A. ONE-PIECE DOOR INSTALLATION:
Connect straight door arm (1) and curved door arm sections (2) to
obtain the longest possible length with hardware (3, 4 & 5). With door
closed, connect straight door arm section to door bracket with a
clevis pin (6). Secure with a ring fastener (7).
Before connecting door arm to trolley, adjust travel limits. Limit
adjustment screws are located on left side panel.
Open Door Adjustment: Decrease up limit. Turn up limit adjustment
screw counterclockwise 4-1/2 turns.
Press door control button. Trolley will travel to full open position (8).
Manually raise door to open position (parallel to floor) and lift door
arm (9) to trolley. The arm should touch trolley just in back of door
arm connector hole (10) as shown in solid line drawing. Increase up
limit if necessary. One full turn equals 7,5cm (3") of door travel.
Closed Door Adjustment: Decrease down limit. Turn down limit
adjustment screw clockwise 4 complete turns.
Press door control button. Trolley will travel to full closed position
(11). Manually close door and lift door arm (12) to trolley. The arm
should touch trolley just ahead of door arm connector hole (10) as
shown in dotted line drawing. Decrease down limit if necessary. One
full turn equals 7,5cm (3") of door travel.
Connect Door Arm to Trolley: With door closed, connect curved arm
to trolley with remaining clevis pin. Secure with ring fastener. NOTE:
Lift door slightly to make connection if necessary.
Run opener through a complete travel cycle. If door has a slight
"backward" slant in full open position, decrease up limits until door
is parallel to floor.
B. SECTIONAL DOOR INSTALLATION:
Connect according to Figure B, then proceed to Step 24.
22
Program your Opener & Remote
Activate the opener only when door is in full view, free of
obstruction and properly adjusted. No one should enter or leave
garage while door is in motion. Do not allow children to operate
push button(s) or remote(s). Do not allow children to play near
the door.
Your garage door opener receiver and remote control transmitter are
set to a matching code. If you purchase additional remote controls,
the garage door opener must be programmed to accept the new
remote code.
Program the Receiver to Match Additional Remote Control
Codes:
Using the "LEARN" Button
1. Press and hold left and right button of the remote control
simoultaneously for about 5 seconds until its LED goes on
constantly for approx. 30 seconds. Now select one of 4 buttons
you wish to operate the gate with (do not press yet).
2. Press and release the "learn" button on the motor unit. The learn
indicator light will glow steadily for 30 seconds.
3. Press now the previously selected button of the remote control.
As control board and remote control are now going to adjust a
matching code, the button on the remote control must be possibly
pressed a second or third time.
4. Release the button when the motor unit light blinks. If light bulb is
not installed, two clicks will be heard.
5. Press one of the remaining 3 buttons of the remote control to end
programming. It has learned the code.
To Erase all Remote Control Codes
To deactivate any unwanted remote, first erase all codes:
Press and hold the "learn" button on motor unit until the learn
indicator light goes out (approximately 6 seconds). All previous codes
are now erased. Reprogram each remote or keyless entry you wish to
use.