Self Diagnostic Tests - Janome NH40 Service Manual

Hide thumbs

Table Of Contents

Table of Contents

Preparation:

1. Turn the power switch off.

2. Move the bobbin winder spindle to the left.

3. Remove the presser foot and raise the presser foot lifter.

4. Turn the hand wheel toward you to raise the needle to its highest position.

Notes:

• Be careful: the sewing machine may start running in its own while in test mode.

• Turn off the power switch before replacing any parts.

• Repeat the diagnostic test until the problem has been resolved.

• You can skip steps in the diagnostic procedure and go directly to the test you want to perform.

(Enter self-diagnostic mode, then select the step number of the diagnostic test you require by

pressing the reverse button)

To begin:

Turn on the switch, if any of the following problems occur, take the recommended actions in the order

they are shown.

1. The machine does not respond when the power switch is turned on:

• Check each connector connection

• Replace the machine socket

• Replace the Switching regulator.

• Replace the A-board

2. The sewing machine lamp does not light up:

• Replace the light bulb

• Replace the A-board

To enter self-diagnostic mode:

If you do not press the next button within 1.5 sec, the machine will revert to normal sewing mode.

Should this occur, start over again from step No.1.

No.1

Turn the power switch on while

pressing the Reverse button.