Table of Contents
Advertisement
Removing the power paddle card
Use this information to remove the power paddle card.
To remove the power paddle card, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Pull power supply 2 slightly out of the rear of the server, just enough to disengage it from the server.
Step 4.
Remove the cover (see "Removing the cover" on page 195).
Step 5.
Remove the power paddle card cover (see "Removing the power paddle card cover" on page 207).
Step 6.
Remove the two screws from the power paddle card and lift it out of the server.
Power paddle card
Figure 206. Power paddle card removal
If you are instructed to return the power paddle card, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the power paddle card
Use this information to replace the power paddle card.
To install the power paddle card, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Install the power paddle card in the server.
Screws
.
Chapter 6
Removing and replacing components
281
Advertisement
Table of Contents
Troubleshooting
