Functional Overview; Front Panel; Rear Panel - Philips HTS3251B/F7 User Manual

FUNCTIONAL OVERVIEW

Front Panel

1 2
* The unit can also be turned on by pressing these buttons.
1. (standby/on) button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
• This button lights up in red when the unit is in
standby mode and turns off when the power is on.
2. Disc tray
• Place a disc after opening the disc tray.
3. A (open/close) button*
• Press to open or close the disc tray.
4. H / G (previous / next) button
• Press to skip to the previous or next title / chapter /
track.
5. C (stop) button
• Press to stop playback.
6. B (play) button*
• Press to start or resume playback.

Rear Panel

1
AC 120V
60Hz
1. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
2. 5.1ch Audio Out jacks (SPEAKERS (4Ω))
• Use to connect supplied 5.1ch speakers.
3. LAN terminal
• Use to connect a telecommunications equipment
with LAN cable.
4. HDMI OUT jack
• Use to connect to a display with an HDMI
compatible port with an HDMI cable.
5. AUDIO IN (AUX1 / AUX2) jacks
• Use to connect an other device with audio out jack
with an RCA audio cable.
6. FM ANT 75Ω jack
• Use to connect the supplied FM wire antenna.
3* 4
2
SPEAKERS 4
SUB- FRONT
REAR FRONT
WOOFER CENTER
5 6* 7 8 9
7. SOURCE button
• Press to switch the active source mode.
8. Infrared sensor window
• Receive signals from your remote control so that
you can control the unit from a distance.
9. Display
• Refer to "Front Panel Display" on page 14.
10. VOLUME jog
• Rotate to adjust the volume.
11. SD CARD slot
• Insert an SD Memory Card and play back the
contents in it.
12. MP3 LINK jack
• Phono input for connecting to the headphone jack
on your portable audio player.
Note
• This unit will be turned into the standby mode
automatically after 25 minutes of no action.
5
3 4
LAN HDMI OUT
AUDIO IN
AUX 1 AUX 2
7. DIGITAL AUDIO IN (COAXIAL) jack
• Use to connect an other device with a digital audio
coaxial output jack with a digital audio coaxial
cable.
8. COMPONENT VIDEO OUT jacks
• Use to connect a TV monitor with component video
inputs with an RCA component video cable.
9. VIDEO OUT jack
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA video cable.
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
10
11 12
7 8
6
DIGITAL COMPONENT VIDEO OUT
FM
AUDIO IN
ANT
Pr Y
75
COAXIAL
Pb
VIDEO OUT
9
EN
EN
11