Garmin GTX 3X5 Installation Manual page 170

NOTES
1
USE 1N4007 DIODE FOR ENCODER POWER.
2 TO GTX #2 IF INSTALLED. RS-232 SPLICE MUST BE MADE ADJACENT TO GTX #1 CONNECTOR AS SHOWN.
CONFIGURE ENCODER OUTPUT TO "TRIMBLE/GARMIN 9600 BPS" FORMAT IF USING RS-232 SOFTWARE
3
METHOD.
4 LIMIT STRAP LENGTH TO SPECIFIED LENGTH IN THE MANUFACTURER'S INSTALLATION MANUAL.
5 POWERING SAE 5-35 THROUGH THE SWITCHED OUTPUT IS OPTIONAL.
6
ALTITUDE MAY BE INPUT ON RS-232 IN 1, RS-232 IN 2, OR RS-232 IN 3.
190-01499-02
Rev. 4
Figure D-16 GTX 3X5 - Altimeter Interconnect
Sheet 2 of 2
GTX 3X5 Transponder TSO Installation Manual
Page D-24