Id Settings; Set The Projector Id; Checking The Projector Id - Epson EB-L25000U User Manual

Installing the Projector
Function
Reset Memory
a
If the mark on the left of the memory name is turned blue, it
means the memory has already been registered. When you
select a registered memory, a message is displayed asking you to
confirm that you want to overwrite the memory. If you select
Yes, the previous settings are deleted and the current settings
are registered.

ID Settings

When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is very useful when managing multiple projectors. You can set up to 30
IDs.
a
• Operation using the remote control is possible only for projectors
that are within the operating range of the remote control.
s "Remote control operating range"
• IDs are ignored when the projector ID is set to Off or the remote
control ID is set to 0.
• If you use Epson Web Control, you can operate a specific projector
from a mobile device.
s "Changing Settings Using a Web Browser (Epson Web Control)"
p.188

Set the projector ID

a
Press the [Menu] button while projecting.
"Using the Configuration Menu"
s
Explanation
Resets the name and settings of a saved memory.
p.23
p.116
b
Select Multi-Projection from Extended.
c
Select Projector ID, and then press the [
d
Press the [ ][ ] buttons to select an ID number.
e
Select Set, and then press the [
f
Press the [Menu] button to close the Configuration menu.

Checking the projector ID

During projection, press the [ ] button while holding down the [ID] button
on the remote control.
When you press the buttons, the current Projector ID is displayed on the
projection screen. It disappears in about three seconds.
37
] button.
] button.