P3100 & P3200 Series
Users Manual
Angle Adapter, P5543
To calibrate gauges with the pressure connection on the rear (e.g. panel-mount gauges) in
their correct position, an angle adapter should be used. The angle adapter fits directly
onto the test station, converting it through 90 degrees, allowing the standard adapters to
be used.
Pointer Remover/Punch, P5551
To remove and refit the pointer of a pressure gauge, a pointer remover/punch should be
used. This tool has a spring-loaded plunger to quickly and consistently refit the pointer.
9-2
Figure 9-2. Angle Adapter
Figure 9-3. Pointer/Remover Punch
gjn022.bmp
gjn023.bmp