Troubleshooting; Distorted Sound - Philips SHC1300 Instructions For Use Manual

SHC1300_booklet 12-01-2006
If a fault occurs, first check the points listed below before taking the set for
repair.
If you are unable to remedy a problem by following these hints, consult your
dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself,
as this would invalidate the warranty.
Problem
No sound

Distorted sound

11:08 Pagina 7

Troubleshooting

Remedy
– Check if the AC/DC adapter is fully inserted
into the AC outlet and that its DC connector is
properly inserted into the 12 Volt DC input
connector located at the rear of the
transmitter.
– Check if the headphone's on/off switch is in
the on position.
– Headphone batteries running low.
(See Headphone power supply)
– Check if the audio source is switched on.
– Volume not adjusted. Adjust the volume on
the audio source/ headphone to a higher level.
– Make use of the SHC1300 transmitter.
Some transmitters already built into other
equipment may not be compatible with the
SHC1300 headphone because of the advanced
technologies used in the SHC1300 headphone.
– Headphone batteries running low.
(See Headphone power supply)
– Check the volume on audio source/
headphone is not set at too high a level.
Reduce the volume.
– Distance from the transmitter is too large.
Move closer to the transmitter.
– Interference from fluorescent lamps/ other
radio sources. Move transmitter or headphone
elsewhere.
– Make use of the SHC1300 transmitter.
Some transmitters already built into other
equipment may not be compatible with the
SHC1300 headphone because of the advanced
technologies used in the SHC1300 headphone.
7