Table of Contents
Advertisement
1.4
SERVICING OF CIRCUIT BOARDS
(1) As a consequence of 1.2, remove the each board.
(2) By connecting the each board as shown in fig.1-4-1.
POW board
CCD board
PRO board
Fig. 1-4-1
Note:
When checking the PRO board and TP board, be sure to
use extension board as shown in fig.1-4-2.
PRO board
Extension board
Part No. KCJ0212
Fig. 1-4-2
1-4
TERMINAL board
Extension board
TP board
TP board
Note:
Connect the VIDEO OUT +/- terminals, which are on the
rear panel, to the +/- terminals on the receiver using twisted
pair cable.
*Recommended Receiver
Manufacturer
Model No.
NITEK
VB37
NVT
NV-213A
NVT
NV-652R
s Recommended wires
• Unshielded Twisted Pair
• Wire gauge 0.5mm (24AWG) or Thicker
• Category Type: 5 (100 Ø)
* When using twisted pair cable, make sure that the +/-
polarities are correct.
Advertisement
Table of Contents
