Husqvarna TS 510 G Operator's Manual page 17

. Hand Controlled Cutting Method:
16
9
6
Hold the Hand Grip (16) and lower the blade
into the material. The blade will return to the
upper position when force is released from the
Hand Grip.
3. Foot Controlled Cutting Method:
2
40
15
18
Push the Foot Pedal (18) using your foot, and
the blade is lowered into the material. The
blade will return to the upper position when
force is released from the foot pedal.
After the Cutting Method has been determined,
move Conveyor Cart () to the front of the
saw so that the blade DOES NOT contact the
material, then place material on Conveyor Cart
Assembly ().
Starting and Stopping:
After determining if the material will be cut wet or
dry, and the deciding on the cutting method, the
engine can now be started.
8
7
41
START (ON)
STOP
Start the engine by using the procedure in the
engine operation manual. Make sure that the
Stop Switch (19) is in the "START" (On) Position
before using the engine starting rope. Open the
engine throttle full open. All sawing is done at full
throttle. Do Not change the engine governor setting
-- it is factory set for the correct speed. See the
"Specifications" section of this document for proper
engine & blade shaft RPM.
WARNING!
Keep hands clear of rotating blade during opera-
tion. READ ALL SAFETY WARNINGS before
operating this machine.
Conventional "Wet" diamond blades MUST be
used with water. DO NOT use conventional "Wet"
diamond blades without water. Using convention-
al "wet" diamond blades without water can result
in injury or death of the operator or persons in the
work area!
When cutting without water use only diamond
blades that are intended to be used dry (with-
out water). Conventional "Wet" diamond blades
MUST be used with water.
Cut the material using one of the Cutting Methods
described in the above section. Gently push the
material into the blade. When the material is com-
pletely cut, return the conveyor cart to the original
position.
Stopping the Unit:
17
19
19
STOP