Husqvarna TS 510 G Operator's Manual page 16

4
Make sure that the Water Pump (4) is engaged
before cutting material. If the Water Pump (4) is
not in the position shown above, loosen the Water
Pump Knobs (5) and push all the way to the right.
Dry Operation:
WARNING!
Conventional "Wet" diamond blades MUST be
used with water. DO NOT use conventional "Wet"
diamond blades without water. Using convention-
al "wet" diamond blades without water can result
in injury or death of the operator or persons in the
work area!
When cutting without water use only diamond
blades that are intended to be used dry (with-
out water). Conventional "Wet" diamond blades
MUST be used with water.
Make sure that the Water Pump (4) is disengaged
before starting the engine. If it is not in the position
shown above, loosen the Water Pump Knobs (5)
and push all the way to the left.
DO NOT run the WATER PUMP (4) for extended
periods of time without water! The WATER PUMP
(4) could be damaged!
• Hint: To reduce vibration of the saw, the water
reservoir pan [of the Frame Assemble (1)] can
be filled with sand. Be sure to remove the water
pump intake Strainer (1) to avoid contaminating
it with dirt or sand.
5
Remove the Water Splash Curtain (17) so that dust
flow freely out the back of the saw. The saw is now
ready for dry cutting.
Cutting Operations:
Cutting Methods: This unit allows three methods for
the blade to contact the material:
1. Fixed Head Cutting Method:
4
40
5
Position the head to the desired height by turn-
ing the Height Adjustment Handle (15). When
the desired height is reached, stop turning the
handle and the cutting head will remain in posi-
tion.
16
CAUTION!
13
17 14
12
2
15
41
18