Panasonic DMP-BD85EB Service Manual page 43

[The Diag Adjustment (SD Diag) start]
9. When below message displayed, perform followings:
a. Insert the SD Diag card to SD card slot.
b. Set the RFKZ0139 SW into "ON".
c. Click the [OK] button.
10. When below message displayed, perform followings:
a. Connect the power cable to the unit.
b. Press the [POWER] button of the unit.
c. Click the [OK] button.
• If the BD Drive has replaced before, the following
replaced date message is displayed, click the [OK] but-
ton for closing the window.
11. The unit is turned on, then "DIAG" is displayed at FL dis-
play and automatically begins adjustment.
12. When below message displayed, perform followings:
a. Remove the SD Diag card from the SD card slot.
b. Disconnect the power cable from the unit.
c. Click the [OK] button.
[LPC Adjustment]
13. When below message displayed, perform followings:
a. Set the RFKZ0139 SW into "OFF".
b. Connect the power cable to the unit.
c. Click the [OK] button.
14. The unit is automatically turned on. After a while the FL
display displays "TEST" and automatically begins adjust-
ment.
When the adjustment is completed, the display is
changed to "ADJ1OK".
[DVD-RAM Adjustment]
15. The disc tray is automatically opened and the following
message is displayed, set the DVD-RAM test disc
(X5RAM-BPS) on the tray and click the [OK] button.
When clicking the [OK] button, the tray is automatically
closed. After a while the FL display displays "ADJ2" and
automatically begins adjustment.
When the adjustment is completed, the display is
changed to "ADJ2OK".
Caution:
Do not press the [OPEN/CLOSE] button of the unit.
16. The disc tray is automatically opened and the following
message is displayed, remove the DVD-RAM test disc
(X5RAM-BPS) on the tray and click the [OK] button.
43