Panasonic EP1022-U1 Service Manual page 32

EP1022-U1
13.5. Power Source Switch Block
1.Remove the bushing cover, and pull out the controller
cord bushing, and then take off the connector.
*In this stage, it is possible to take off the controller block
from the chair.
2.Remove two screws and pull out the power source switch
block.Take off the connector of power supply and remove
screw connecting the grounding lead wire.
3.Remove screws and pull out the power source sw
bracket.
*If required to replace the fuse, after second step, pull out
the fuse holder and replace the fuse inside.
32