System Management - ZyXEL Communications PES-100 User Manual

3. Reset Device
This item is used to reset the switch.
4. Save Setting
This item saves the current system/port configuration in the flash memory. The
configuration will be available after system reset or power cycle.
5. Factory Defaults
This item is used to reset the system to the factory default. Select this item when
your current configuration is not working.
6. Quit
Exit and end the management session.
5.1

System Management

You can configure the following items in System Management:
Ø
System Name: Enter a name for the switch.
Ø
System Location: Enter the switch's physical location.
Ø
System Contact: Enter the name of the person to contact if there is
any problem with the switch.
Ø
IP Address: Enter the IP address of the switch.
Ø
Subnet Mask: Enter the IP subnet mask of the switch.
Ø
Default Gateway: Enter the IP address of the default gateway (first
hop router) of the switch.
Ø
DNS IP: Enter the IP address of the DNS (Domain Name System)
server.
Ø
Domain name: Enter the domain name of the switch.
Ø
Trap Manager: A maximum of 3 trap managers is allowed. If you
enable Trap Report Status, then a trap is sent to the trap managers
when any of the following events occurs:
PES-100 Phoneline Ethernet Switch
Factory Defaults
System Reset
System Cold Start
Save Setting
User Login via Telnet
Grab index.htm via web Management
Port links up
Port links down
Error rate is over threshold
Authentication Failure for SNMP
10