Features; Electronic Control Instructions And Operating Modes - Danby DPA120BCCWDB Owner's Use And Care Manual

Features

ELECTRONIC CONTROL INSTRUCTIONS AND OPERATING MODES

Swing Button: Press to start the auto swing feature. When auto swing is activated, press again to stop the louver at
the desired angle.
Fan Button: Press to select fan speed; normal or high. Light will indicate current speed.
Timer Button: Press to start the Auto-on or Auto-off features. Light will indicate whether a timer is set.
Sleep / Filter Button: Press to start the Sleep feature. Also used to reset the fi lter after 250 hours of operation.
- Press the SLEEP button to begin SLEEP mode
- The temperature will increase by 2 degrees from set temperature over a 2 hour period
- The unit will hold the new temperature for 7 hours and then will return to the set temperature
- The fi lter light will illuminate after 250 hours of use as a reminder to clean the fi lter; to reset the fi lter after cleaning,
hold the SLEEP button for 3 seconds
Mode Button: Press to select the desired mode. Modes will cycle in sequence with each press of the button; AUTO,
COOL, DRY, FAN. Light will indicate current mode.
AUTO mode
- press the mode button until the AUTO icon illuminates.
- Press the UP or DOWN arrow buttons to select the desired room temperature
- The unit will automatically select cooling and fan speed based on ambient temperature.
COOL mode
- Press the mode button until the COOL icon illuminates
- Press the UP or DOWN arrow buttons to select the desired room temperature
- The temperature can be set within a range of 17-30°C / 62-86°F
- Press the fan button to choose the fan speed
DRY mode
- Press the mode button until the DRY icon illuminates
- Press the UP or DOWN buttons to select the desired room humidity
- The humidity can be adjusted in 5% increments between 35% and 85%
- The fan speed will remain on normal in DRY mode and cannot be adjusted
FAN mode
- Press the mode button until the FAN icon illuminates
- Press the fan button to choose the fan speed
Up and Down Buttons:
- Press and hold both Up and Down buttons for 3 seconds to change the temperature display from °C to °F.
Power Button: Press to turn the unit on or off.
LED Display: Shows the set temperature in °C or °F or the auto-timer settings. While on DRY mode shows the rela-
tive humidity. When on FAN mode shows the room temperature.
3sec
Note: The hose should be exhausted during COOL mode
5