Water Drainage - Danby DPA120BCCWDB Owner's Use And Care Manual

Installation Instructions

WATER DRAINAGE

When the internal drain pan becomes full the unit will beep 8 times and the
digital display will show error code P1. The air conditioning or dehumidifying
action will stop but the fan may continue to operate.
Turn the unit off and unplug it from the power source. Carefully move the unit
to a location where the water can be drained. Remove the bottom drain plug
and allow the water to completely drain. Replace the bottom drain plug, press-
ing fi rmly to ensure a tight fi t and no leaks. The P1 error symbol will disappear
and the unit will resume regular function once power is restored.
If the P1 error persists when the unit has been drained of water, turn the unit
off and unplug it from the power source for at least 5 minutes. If the P1 error
persists after plugging the unit back in, please call Danby consumer care for
further toubleshooting options.
During the DRY mode, you may wish to set up the
continuous drain option so that the unit will automati-
cally drain collected water.
Remove the exhaust hose during DRY mode, it is
not necessary. Ensure that the unit is turned off and
unplugged from the power source before setting up
the drain hose.
Remove the upper drain plug and attach the drain
hose that was provided with the unit. Ensure that there
are no kinks or bends in the drain hose as this can
stop water from draining.
Place the open end of the drain hose over the re-
ceptacle that the unit will drain into; this could be a
basement fl oor drain, a sink or similar.
Remember that there is no drain pump in this unit, the
continuous drain is activated by gravity only. Ensure
that the drain hose goes straight down toward the fl oor
from the drain connection. If the hose is not positioned
directly downwards, water will not drain correctly.
12