Mounting The Volume Control Security Cover - Camco Q-POWER 10 User Manual

4.8 Mounting the Volume Control Security Cover

It is possible to install a solid protection over the volume controls to prevent
intentional or unintentional changes of the amplifi er volume settings.
WARNING: Disconnect the amplifi er from the mains before installing the
cover.
In the original state the holes needed to fi x the security cover on both sides of
the volume knobs are hidden behind the plastic front label. In case you wish to
install the cover please fi rst pierce two holes in the front label to facilitate the
screwing, as shown in the drawings.
To fi nd the exact positions of the holes take the included cardboard template
you will fi nd attached on the last page of this manual and place it on top of
the volume knobs. The positions of the hidden screw holes are indicated on
the template. Then fi rmly pierce and turn with a pointed tool (we recommend a
Philips PH1 recessed head screwdriver) through the cardboard and the label at
these positions to obtain a clean hole. You now should see the metal of the fi ne
pitch thread behind the label.
Then remove the cardboard template and fi x the cover with the two included
M3 recessed threaded screws.
WARNING: Do not use any pointed tools (e.g. screwdriver) with a diameter of
less than 3,5 mm (0,138 in), as they might be stucked too deeply inside the am-
plifi er and damage components.
P. 19
USER MANUAL
Q - P O W E R S E R I E S
Q - P O W E R
S E R I E S