Camco Q-POWER 10 User Manual page 13

3.1 Mains supply
When mounting or connecting the amp always disconnect it from mains.
Only connect the Q-POWER amplifi er to an appropriate AC circuit and
outlet, according to the requirements indicated in the second line on the
rating plate.
MODEL:
OUTPUT PWR PER CH/IMP:
SER. NO. :
MODEL:
OUTPUT PWR PER CH/IMP:
SER. NO. :
Exemplary rating plates for a mains supply of 120 / 230 V ~ 50/60 Hz.
Power Supply Data:
Voltage
Q-POWER 6 120 / 230 V
Q-POWER 10 120 / 230 V
P. 11
USER MANUAL
Q - P O W E R S E R I E S
Q-POWER 6
120 / 230 V ~ 50 / 60 Hz 1600 W
1000 W / 4 Ohm
45800 MADE IN GERMANY
Q-POWER 10
120 / 230 V ~ 50 / 60 Hz 1500 W
1800 W / 4 Ohm
MADE IN GERMANY
45800
Mains Frequency Current Power Consumption
50 / 60 Hz 22 / 12 A 1600 W
50 / 60 Hz 21 / 11 A 1500 W
3.2 On/Off switch
The On/Off switch is a rocker-type switch. It is located on the right side of the
front panel. To turn the amplifi er on, push in on the upper part of the switch. This
initiates start-up by activating the inrush current limiter. During power up the
clip and signal LEDs will light up in red for a few seconds. To turn the amplifi er
off, push in on the lower part of the switch.
The amplifi er is switched on. The amplifi er is switched off.
NOTE: This switch does NOT disconnect the amplifi er from mains.
The switch initiates start-up by activating the current limiting function. As soon
as the power amplifi er is connected to the mains power supply, a voltage is
supplied to both the line-fi lter and the fused input of the controllable rectifi er.
Disconnecting the amplifi er from the main power supply can only be achieved
by physically separating the amplifi er from the mains by pulling the mains plug.
The mains plug therefore has to be freely accessible. Disconnect the mains plug
from the mains during a lightning storm or when the amplifi er remains unused
or un-supervised for a prolonged period of time. Alternatively, you can discon-
nect the amplifi er via an external all-pole disconnection from the mains.
If a power cut occurs while the amplifi er is switched on, it will restart auto-
matically once the power supply has been restored. All settings prior operation
to the loss of power will be maintained.
Q - P O W E R
S E R I E S