Indicators; On Leds; Signal / Protect Leds (Multifunctional); I-Out Leds - Camco Q-POWER 10 User Manual

4.1 Indicators

4.1.1 On LEDs

Under normal operation, after the amp has started, the green power LEDs are
permanently lit.

4.1.2 Signal / Protect LEDs (multifunctional)

The green Signal LEDs are illuminated when the voltage level at the output
reaches approx. 4 V; this corresponds to a power of approx. 4 W into a 4 Ohm
load. The channel signal LEDs are illuminated red when the amplifi er is in Protect
Mode (Mute), for example because of persistent DC-voltage at the outputs or
overheating.
P. 15
USER MANUAL
Q - P O W E R S E R I E S

4.1.3 I-Out LEDs

The brightness is proportional to the output current in the channel. Output cur-
rent of approx. 1 A lights up the LED at its lowest brightness level, while full
brightness corresponds to the maximum rated current.

4.1.4 Clip LEDs

This LED indicates an overloading of the amplifi er when the power output level
is to high.
Q - P O W E R
S E R I E S