Honeywell STT25D Operator's Manual page 9

To set the Input Latching to LATCHED
To set the Input Latching to NOT
LATCHED
To turn on the NAMUR configuration
To turn off the NAMUR configuration
To enable Write Protection
To disable Write Protection
ATTENTION: To change the PASSWORD
NOTES:
1. Enter the 4 character password.
2. Enter the NEW 4 character password in numeric or capital alpha characters.
3. PLEASE USE EXTREME CAUTION WHEN USING THIS INDEX. THE OLD
PASSWORD IS NOT VALIDATED BEFORE ENTERING THE NEW PASSWORD.
4. The fall-back password is an algorithm based on the unit serial number. If the
password is lost, contact your regional Technical Assistance Center (TAC) with
the serial number.
•
Method 2:
Open one of the 6 Generic Property Sheets set up to configure each of the following:
1. Input Status Latching à On
2. Input Status Latching à Off
3. "NAMUR" Configuration à On
4. "NAMUR" Configuration à Off
5. Enable Database Write Protection
6. Disable Database Write Protection (via user entered password).
NOTE: Since no template is provided for changing the password, use the
BLANK.GDT file described in Method 1 to change the password.
Action
Input Status Latching à ON
Input Status Latching à OFF
"NAMUR" Configuration à On
"NAMUR" Configuration à Off
Enable Database Write Protection
Disable Database Write Protection
Once you select the template, download the template to the STT250.
6 Smart Temperature Transmitter STT250 – Operator Manual
INDEX DATA TYPE
0 UInt8
0 UInt8
8 UInt8
8 UInt8
12 UInt8
13 String
14 String
Select the "File - New" menu which
displays the "Add File Template". Select
"Generic Templates" TAB and:
LATCHED.GDT file
NOTLATCH.GDT file
NAMON.GDT file
NAMOFF.GDT file
ENABWP.GDT file
DISABWP.GDT file
VALUE
103
102
1
0
255
XXXX
(Note 1)
XXXX
(Note 2)
(Note 3)