Configuring The Server; Configuring The Onboard Sata Controller - Fujitsu PRIMERGY RX1330 M3 Operating Manual

– After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS or in iRMC S4).
– iRMC S4
iRMC S4 offers various options for switching the server on and off, e.g. via
the Power On Off page of the iRMC S4 Web interface.
6.4

Configuring the server

This section contains information about configuring the server and installing the
operating system.
I
Make sure that the power saving functions are disabled in the Power
menu of the BIOS Setup during operation.
6.4.1

Configuring the onboard SATA controller

A SATA controller is integrated on the system board. You can configure the
onboard controller either before or during installation with the ServerView
Installation Manager. Using the ServerView Installation Manager is
recommended.
I
The controller has its own configuration utility. For further information,
refer to the "Embedded MegaRAID Software User's Guide" (on the
Fujitsu manuals server under x86 Servers - Expansion Cards - Storage
Adapters - LSI Configuration Software).
I
Descriptions of operating systems not covered in the controller manual
are provided in the corresponding readme under:
http://www.fujitsu.com/global/services/computing/server/ia/driver/index.html
For Japan:
http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
RX1330 M3
Operating Manual
Starting up and operation
73