Table of Contents
Advertisement
5.25-inch Device
The server contains two slots in which backup devices including CD-ROM and magnetic tape
drives can be installed.
IMPORTANT:
Set "OFF" for the terminating resistor of the backup device you are
!
going to install, and set a SCSI ID different from those of other devices.
For the settings, see the manual provided with the server.
Install only a backup device specified by the server manufacturer.
!
The media devices should be installed in the first available media bay
!
from the bottom (slot 1).
Installation
See the section Preparing for Upgrade described earlier in this chapter.
1.
Remove the left-hand side access panel as described earlier in this chapter.
2.
Remove the dummy cover from the bay where you are installing a media device. The
3.
dummy cover is released by removing the two screws holding it. Save the dummy cover
and screws for future use.
: When installing a full-height device, remove the two dummy
NOTE
covers.
Slot 2
Slot 1
Upgrading your Server 7-25
Advertisement
Table of Contents
