Installing A 5.25-Inch Media Device - NEC EXPRESS5800/120Lf User Manual

Installing a 5.25-Inch Media Device

To install a 5.25-inch media device, perform the following procedures:
1. Observe the safety and ESD precautions listed under General Information
and Static Precautions at the beginning of this chapter.
2. Prepare your system for upgrade. See Preparing Your System for Upgrade
described earlier in this chapter.
3. Remove the left-hand side access panel as described earlier in this chapter.
Observe static precautions. Use an antistatic wrist strap.
4. Remove the dummy cover from the bay where you are installing a media
device. The dummy cover is released by removing the two screws holding it
in place (see Figure 4-30). Save the dummy cover and screws for future use.
Note:
dummy covers.
5. Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
6. Set any drive jumpers or switches before you install the drive. See the
documentation that comes with the device for jumper or switch information.
7. Attach the mounting rails to the device with the four screws that come with
the device, as shown in Figure 4-31.
Note:
them. Remove any rails already attached.
! CAUTION
When installing a full-height device, remove two
Figure 4-30. Removing the Dummy Cover
If the drive comes with drive rails, do not use
Upgrading Your System 4-33