Fluid Capacities - Fiat 500e 2017 Owner's Manual

Tail Lamp Assembly Screws
3. Remove four screws and separate the backplate from
the lamp housing.
4. Remove the tail, stop, or turn signal bulbs by push-
ing them slightly and turning counter-clockwise.
5. Remove the backup lamp bulb by pulling straight out.

FLUID CAPACITIES

Systems
Power Electronics Cooling System
Battery Thermal Management Cooling System
Single-Speed Transmission
MAINTAINING YOUR VEHICLE 271
6. Replace lamps as required and reinstall lamp.
Center High Mounted Stop Lamp (CHMSL)
1. Remove the two guard caps and the two fastening
screws.
2. Remove the center high mounted stop lamp assem-
bly.
3. Disconnect the electric connector.
4. Press the retaining device and open the bulb holder.
5. Remove the snap-fitted bulb to be replaced and
replace it.
6. Close the back cap locking it properly.
7. Reinstall the two fastening screws and reinstall the
guard caps.
U.S.
3.6 Quarts
7.0 Quarts
0.8 Quart
7
Metric
3.5 Liters
6.7 Liters
750 ml