Table of Contents
Advertisement
216 STARTING AND OPERATING
A system fault can occur due to any of the following:
1. Signal interference due to electronic devices or driv-
ing next to facilities emitting the same radio frequen-
cies as the TPM sensors.
2. Installing aftermarket window tinting that contains
materials that may block radio wave signals.
3. Accumulation of snow or ice around the wheels or
wheel housings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPM sensors.
NOTE:
• The TPMS will not monitor the pressure in a replace-
ment tire installed without a tire pressure sensor.
• If you install a replacement tire in place of a road tire
that has a pressure below the low-pressure warning
limit, upon the next ignition switch cycle, the "Tire
Pressure Monitoring Telltale Light" will remain on
and a chime will sound. In addition, the highlighted
graphic in the instrument cluster will still display a
low pressure text message and a pressure value in a
different color.
• After driving the vehicle for up to 20 minutes above
15 mph (24 km/h), the "Tire Pressure Monitoring
Telltale Light" will flash on and off for 75 seconds
and then remain on solid. In addition, the instrument
cluster will display a "Service Tire Pressure Monitor-
ing System" message.
• For each subsequent ignition switch cycle, a chime
will sound, the "Tire Pressure Monitoring Telltale
Light" will flash on and off for 75 seconds and then
remain on solid, and the instrument cluster will
display a "Service TPM System" message.
Once you repair or replace the original road tire and
reinstall it, the TPMS will update automatically. In
addition, the "Tire Pressure Monitoring Telltale Light"
will turn off, as long as no tire pressure is below the
low-pressure warning limit in any of the four active
road tires. The vehicle may need to be driven for up to
20 minutes above 15 mph (24 km/h) in order for the
TPMS to receive this information.
Advertisement
Chapters
Table of Contents
