13. TECHNICAL INFORMATION..................17 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 General Safety This appliance is intended to be used in household and •...
ENGLISH from the mains socket. Contact the • Do not put flammable products or Authorised Service Centre to replace items that are wet with flammable the water inlet hose. products in, near or on the appliance. 2.4 Use 2.5 Disposal •...
• When the programme starts, a red light The Beam-on-Floor goes off comes on and stays on for all the when the appliance is duration of the programme. deactivated. • When the programme is completed, a green light comes on.
ENGLISH Programme Degree of soil Programme pha- Options Type of load • Fresh soil • Wash 60 °C • Multitab • Crockery and • Rinses cutlery • All • Prewash 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil.
• The deactivation of the rinse aid Press and hold simultaneously dispenser when you want to use the until the appliance is in Multitab option without rinse aid. programme selection mode. • The level of rinse aid according to the required dosage.
Page 9
ENGLISH • The indicator continues to 3. Press again and again to change flash. the setting. Each time you press • The end indicator starts to flash. the level increases. After level 6 you go The number of flashes indicates to level 0 and then start again from the level.
There is also an acoustic signal that 2. Press sounds when the programme is • The indicators completed. By default this acoustic signal is deactivated but it is possible to activate go off. • The indicator continues to flash.
ENGLISH 8.2 How to fill the rinse aid dispenser 4. Remove the salt around the opening of the salt container. CAUTION! Only use rinse aid specifically 5. Turn the cap of the salt container designed for dishwashers. clockwise to close the salt container. 1.
9.1 Using the detergent 3. Press the button related to the programme you want to start. The related programme indicator comes 4. Close the appliance door to start the programme. Starting a programme with delay start 1. Set a programme.
ENGLISH Cancelling the programme End of programme When the programme is completed and Press and hold simultaneously you open the door, the appliance is until the appliance is in automatically deactivated. programme selection mode. Close the water tap. Make sure that there is detergent in the detergent dispenser before you start a new programme.
• Do not put in the appliance items made • The filters are clean and correctly of wood, horn, aluminium, pewter and installed. copper. • The cap of the salt container is tight. • Do not put in the appliance items that •...
ENGLISH 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4.
• If you regularly use short duration recommend to run long duration programmes, these can leave deposits programmes at least 2 times per of grease and limescale inside the month. appliance. To prevent this, we 12. TROUBLESHOOTING If the appliance does not start or it stops...
ENGLISH 12.1 The washing and drying results are not satisfactory Problem Possible solution There are whitish streaks or • The release quantity of rinse aid is too much. Adjust bluish layers on glasses and the rinse aid selector to a lower position. dishes.