Advertisement
[3] key Key pressed briefly : Power ON time is displayed.
During Power On time display, by pressing for at least 2
seconds, the Power ON time is cleared.
(Display) PonTim_0Hxx_ (00~50 is displayed for "xx".
xxxxx
[4] key Key pressed briefly : CD operation time is displayed.
During CD operation time display, by pressing for at least
2 seconds, CD operation time is cleared.
(Display) CDTim_0Hxx_ (00~50 is displayed for "xx".
xxxxx
[5] key Key pressed briefly : CD EJECT number is displayed.
During CD EJECT number display, by pressing for at
least 2 seconds, CD EJECT number display is cleared.
(Display) EjeCnt_xxxxx
[6] key Key pressed briefly : PANEL Open/close number is
displayed. (*1)
During PANEL Open/close number display, by pressing
for at least 2 seconds, PANEL Open/close numbers is
cleared.
(Display) PnCnt_xxxxx
[FM]
ROM correction version display
key
(Display) SYS_ROM_R123
(Display) PAN_ROM_R123
When E2PROM is not installed : ROM_ERR_
When un-written : ROM_R – – –
When data is incompatible : ROM_R ∗ ∗ ∗
[
]
AUDIO data default value setting
key
(Display) AUDIO_INIT
TEST MODE
When less than 1 hour, displayed
by increments of 10 minutes.)
(00001~10922 is displayed for
"xxxxxx".) MAX 10922 (times)
When less than 1 hour, displayed
by increments of 10 minutes.)
(00001~10922 is displayed for
"xxxxxx".) MAX 10922 (times)
MAX 65535 (times)
MAX 65535 (times)
KDC-MP832U
[
]
Key pressed briefly : Forced Power OFF data displayed.
key
While the forced power OFF data is displayed, press and
hold for 2 seconds to clear the data.
(Display) POFF_ - - - (No Forced Power OFF)
SEC
(Forced Power OFF because of
missing Security Code)
PNL
(Forced Power OFF because of
system µ-com panel communication
error)
[
]
Key pressed briefly : CD information display mode ON/OFF
key
While in CD information display mode, press and hold for
2 seconds to clear all CD information.
∗ Please refer to the table below.
(*1) : 1 count is made when the panel opens to full or when a disc is
loaded.
CD information display mode
Displays I2C communication status and CD mechanism
error log
(Display) I2C_
____________
(Display) ERR_1-
, 2-
"OK" or "NG" is displayed for "
is displayed for "
".
Displays CD loading error data.
(Display) Load_Error____
(Display) __ (1) xx__ (2) xx (number of times is displayed
Disk detection switch ON/OFF is monitored, and when
the loading operation is not completed within the specified
time length, or when E-99 mechanism error occurred,
record which SW signal had an error.
∗Refer to the note at the end of [CD LOAD error detection].
[AM]
Displays CD ejection error data.
key
(Display) Eject_Error___
↑
(Display) __ (1) xx__ (2) xx
(Display) __ (3) xx__ (4) xx (number of times is displayed
Disk detection SW ON/OFF is monitored, and when the
ejection operation is not completed within the specified
time length, or when E-99 mechanism error occurred,
record which SW signal had an error.
∗Refer to [CD EJECT error detection]'s note.
, 3-
". / "--" or an error code
for "xx")
MAX 99 (times)
for "xx")
MAX 99 (times)
19
Advertisement
