Attaching The Connector Locking Collar - Raymarine RV-100 RealVision 3D Installation Instructions Manual

Attaching the connector locking collar

The transducer cable's connector is supplied with a separate locking collar assembly, used to secure
the cable firmly to your multifunction display.
This procedure describes how to attach the locking collar to the connector. The locking collar parts
are supplied in a separate bag, in the box with your transducer.
Important: Ensure that you route the cable all the way to your multifunction display before
attaching the locking collar.
1. Slide the locking collar over the end of the connector, then push it towards the cable-end of
the connector.
Important: Ensure that the lugs on the locking collar (labelled 'A' in the illustration), are closest to
the plug-end of the connector.
2. Slide the split-ring over the end of the connector, then push it towards the cable-end of the
connector.
Important: Ensure that the tabs on the split-ring (labelled 'B' in the illustration), are closest to the
cable-end of the connector.
14