Finalizing the transducer mounting
Once you have achieved optimum performance at the desired vessel speeds the transducer must be
locked into position to complete the installation.
1. Drill the locking hole location taking care not to damage the mounting bracket.
2. Fill the locking hole with marine grade sealant.
3. Secure the transducer and bracket by fully tightening all 3 mounting screws.
4. Secure the transducer hanger by tightening the mounting bolt; do not exceed a torque of 35 Nm
(25.8 ft lb). The transducer hanger should not be easily moveable by hand, and should remain in
its normal operating position when your vessel is underway.
21