Configuration Using The Device Master Data (Gsd) In Step 7 - Siemens 3RW44 Manual

Requirements for commissioning
Table 9- 2
Prior activity
1. Soft starter has been installed
2. PROFIBUS DP communication module has
been installed
3. The station address has been set on the soft
starter
4. The soft starter has been configured
(configured and parameterized)
5. The supply voltage for the DP master is
switched on
6. The DP master is switched to the RUN
operating state
9.6.2

Configuration using the Device Master Data (GSD) in STEP 7

Table 9- 3
Step
1
2
3
4
5
3RW44 soft starters
Manual, 03/2017, NEB535219502000/RS-AB/008
9.6 PROFIBUS DP commissioning using the GSD file in STEP 7 (example)
Requirements for commissioning
Commissioning
Description
Activate the PROFIBUS DP communication module as described in chapter Activating
the PROFIBUS DP communication module (fieldbus interface) and setting the station
address (Page 156).
Set the required station address as described in chapter Activating the PROFIBUS DP
communication module (fieldbus interface) and setting the station address (Page 156).
Switch on the supply voltage for the DP master CPU 315-2 DP at the infeed module.
Observe the status LEDs of the DP master CPU 315-2 DP on the infeed module:
5 V DC: Lights up
SF DP: Off
BUSF: Flashing
Start the SIMATIC Manager and create a new project with a DP master (e.g. CPU315-
2 DP with DI 16 x DC 24 V and DO 16 x DC 24 V). Generate OB1 and OB82 for the
project.
PROFIBUS DP communication module
For more information, see ...
Chapter Installation, connection and feeder
configuration (Page 29).
Chapter Installing the PROFIBUS DP
communication module (Page 153).
Chapter Activating the PROFIBUS DP
communication module (fieldbus interface) and
setting the station address via the device
interface using the "Soft Starter ES Premium" or
the "Soft Starter ES Smart + SP1" software
(Page 160).
Chapter Configuring soft starters (Page 162).
DP master manual
DP master manual
165