The Autoset 1500 Front Panel - Honeywell AutoSet 1500 User Manual

The AutoSet 1500 front panel

Zero
cam
LED
Reset button
. Three-digit tonnage displays show the tonnage at each strain link.
Tonnage displays
Tonnage displays flash when an overload occurs.
Setpoint displays.
setpoints). AutoSet creates setpoints automatically based on the load. AutoSet stops the
press if these limits are exceeded.
This button has two functions. Pushing it momentarily (less than two sec-
Reset button.
onds) resets AutoSet after it signals an overload and stops the press. When an overload
occurs, the tonnage display for the strain link where the overload occurred will flash.
(Both displays will flash if an overload occurs on both sides of the press.) The press
stops. Once AutoSet is reset, the displays stop flashing. You can once again run the press.
Be sure to check for the cause of the overload first.
Holding the button down for more than two seconds signals AutoSet to recalculate
setpoints the next time the press is started. (This can be done while the press is running.)
To recalculate, the button should always be held down until the numbers in the setpoint
display blink once and change to 120% of the full scale tonnage set on AutoSet.
Complete instructions for using the reset button are in Chapter 4.
(optional). Illuminates when the zero cam is closed, generally through top
Zero Cam LED
of stroke.
AutoSet 1500 has a lock and key so the cover can be locked. This prevents
Keylock.
unauthorized changes to settings.
The two cover latches keep the AutoSet front panel door firmly closed. To
Cover latches.
make settings on AutoSet, you unlock the box and loosen the two latches. Then swing the
front panel door open. All settings are made inside the box.
AutoSet 1500 User Manual
LOAD
L E F T
ZERO CAM
SETPOINTS
RESET
AutoSet ® 1500
W I N T R I S S L O A D A N A L Y Z E R
Figure 1-1. AutoSet front panel
Three-digit setpoint displays show the the upper load limits (or
R I G H T
Setpoint
displays
2
AutoSet 1500
Tonnage
displays (for
forward or
reverse)
Cover latches
(keylock in between)
Ch 1 1088500