Advertisement
See the photo below to determine which color goes into which chamber. You must
not make a mistake on this, it is vital to be correct. Use a felt tip pen and label
each chamber with the correct letters.... K, C, M, Y.
Do not remove foil pull tabs from top of cartridges.
ARC-SO20089-E = ARC-SO20191-E
Follow these steps for each chamber, starting with Black.......
A) Use the Bottom Fill Adapter and puncture the clear seal over the exit port for the
color you are about to inject. Only puncture the one you are going to put ink into.
B) Unwrap the syringe, remove the protective cap, and attach a green needle to the end
of the syringe. Twist it on with your fingers, so it is tight.
C)
Make sure the syringe plunger is down all the way, then insert the tip of the needle
into the ink and pull ink into the syringe. Pull in a 1/2 to 1 cc more than is shown in
the table above. (For the black you will have to do this in two steps, 11 cc , and 11 cc
more).
D)
Hold the syringe, needle pointed up, and remove the needle and attach the Bottom
Fill Adapter.
S a v e
M o n e y
MIS Associates Inc
http://www.inksupply.com
Color
Black
Cyan
Magenta
Yellow
a n d
I m p r o v e
2901 Auburn Rd
Fax: 248-289-6013
Volume (cc)
22
10
10
10
This is important.
ARC-SO20108-E = ARC-SO20189-E
Y o u r
Auburn Hills, MI 48326
Email: sales@inksupply.com
P r i n t i n g
800-445-8296
Advertisement
