Setting A Drivelock Master Password; Enabling Drivelock And Setting A Drivelock User Password - HP EliteBook x360 1030 User Manual

To manually apply DriveLock protection to an internal hard drive, a master password must be set, and
DriveLock must be enabled in Computer Setup. Note the following considerations about using DriveLock
protection:
After DriveLock protection is applied to a hard drive, the hard drive can be accessed only by entering
●
either the DriveLock user password or the master password.
The owner of the DriveLock user password should be the day-to-day user of the protected hard drive.
●
The owner of the DriveLock master password may be either a system administrator or the day-to-day
user.
The DriveLock user password and the DriveLock master password can be identical.
●

Setting a DriveLock master password

To set a DriveLock master password, follow these steps:
1. Start Computer Setup.
Computers or tablets with keyboards:
●
1.
2.
Tablets without keyboards:
●
1.
2.
2. Select Security, make the selection for Hard Drive Utilities, select DriveLock/Automatic DriveLock,
and then press enter.
3. Select the hard drive you want to protect, and then press enter.
4. Select Set DriveLock Master Password, and then press enter.
5. Carefully read the warning.
6. Follow the on-screen instructions to set a DriveLock master password.
NOTE:
Setup. For more information, see
on page
7. To exit Computer Setup, select Main, select Save Changes and Exit, and then select Yes.

Enabling DriveLock and setting a DriveLock user password

To enable DriveLock, and set a DriveLock user password, follow these steps:
1. Start Computer Setup.
Computers or tablets with keyboards:
●
1.
2.
Tablets without keyboards:
●
ENWW
Turn off the computer.
Press the power button, and when the HP logo appears, press
Turn off the tablet.
Press the power button in combination with the volume down button until the Startup menu
is displayed, and then tap f10 to enter Computer Setup.
You can enable DriveLock and set a DriveLock user password before exiting from Computer
45.
Turn off the computer.
Press the power button, and when the HP logo appears, press
Enabling DriveLock and setting a DriveLock user password
f10 to enter Computer Setup.
f10 to enter Computer Setup.
Using passwords 45