Table of Contents
Advertisement
4.7 Options for standby mode 39
To adjust the transparency level of the OSD, set the OSD Trans-
parency option as you desire. Its available range is 0 to 50 per-
cent.
To adjust the display time of the information box, set the Info
Box Display Time option as you desire. Its available range is
1 to 30 seconds. If you set this option to No Info Box, the in-
formation box will not be displayed when you switch services.
However, pressing the
button will display the information
box. If you set this option to Never Hide, the information box
will always be displayed. For the information box, see §5.2.3.
In addition, you can raise or lower the position of the infor-
mation box. To do that, set the Info Box Position option as you
desire. Its available range is 10 to +3 lines. The higher you set
the option, the lower the information box will be positioned.
To use an animation effect when changing menu, set the Ani-
mation option to Enable.
If any service's name is too long to fit the width of the service
name column on the services list screen, you can get it to scroll
by setting the Text Scroll option to any other than Disable. With
the choice of Full Scroll, it will be fully scrolled until its end
disappears; with the choice of Part Scroll, it will be scrolled
only to its end.
4.7 Options for standby mode
You can display the current time on the front display in
standby mode. To display the time, select the Settings > Mis-
cellaneous menu and set the Standby Mode option to Active;
otherwise, set it to Passive. When you set the Standby Mode
option to Active, the receiver can also bypass the signal from
the antenna.
To save power consumption, you might as well set the Auto-
matic Power Down option to Enable. With this option enabled,
the receiver will be turned off automatically when there is no
manipulation over three hours.
Advertisement
Table of Contents
