Alpine IVA-D310R Service Manual page 65

No. Symbol
91 SYNC-SEL
92 PORTGND1
93 OSD-SCLK
94 OSD-CS
95 OSD-SOUT
96 DVD-SRQ
97 RGB-CLK
98 RGB-CS
99 RGB-DO
100 VGL-CONT
101 VGH-CONT
102 PORTVDD2
103 TILT-PHOTO
104 15-SW
105 END-SW
106 FULL-SW
107 IS-RXD
108 IS-TXD
109 IS-FOUT
110 TILT-SW
111 TER-SI
112 TER-SO
113 TER-SCL
114 BL-OFF
115 ENC-B
116 ENC-A
117 NAVI-RXD
118 NAVI-TXD
119 NAVI-CONT
120 TP-SEL4
121 TP-SEL3
122 TP-SEL2
123 TP-SEL1
124 FFB-TRG
125 ZERO-DET IN
126 (BL-CANSEL)
127 FFB RESET
128 VDD1
129 MTR-LVL1
130 MTR-1
131 GND1
132 MTR-2
133
NC
134
135 TP-X
136 TP-Y
I/O
O Synchronous signal switching signal output terminal. (H : NAVI side)
- GND terminal for Port. (connect to GND)
O Clock signal output terminal to OSD.
O Chip enable signal output terminal to OSD.
O Serial data output terminal to OSD.
I Status request signal input terminal from DVD Mechanism. (EPF III communication)
O Clock signal output terminal to RGB decoder.
O Chip enable signal output terminal to RGB decoder.
O Serial data output terminal to RGB decoder.
O LCD power supply -10V output control signal output terminal.
O LCD power supply +15V output control signal output terminal.
Power supply terminal for Port. (P04-P07, P20-P27, P120-P127, P130-P133,
-
P140-P147, P150-P157) (connect to VDD+5V)
I TILT-PHOTO pulse signal (Monitor angle) input terminal.
I Active NOSE position/condition detection SW signal input terminal.
I RX signal terminal for IS-BUS communication.
O TX signal terminal for IS-BUS communication.
O FRAME-OUT signal terminal for IS-BUS communication.
I Active NOSE position/condition detection SW signal input terminal.
I Serial input terminal for connecting terminal.
O Serial output terminal for connecting terminal.
O Serial clock terminal for connecting terminal.
O Backlight power supply control signal output terminal. (H : ON, L : OFF)
I Rotary Encoder signal input terminal.
RX signal terminal for UART communication to NAVI.
I
(NAVI side : EXTX (as usual DISP CONT))
TX signal terminal for UART communication to NAVI.
O
(NAVI side : EXRX (as usual WIDE/NORM))
NAVI communication error recovery deal terminal.
I
(inputted the same signal as NAVI-RXD)
O Touch Panel signal terminal.
O Force feedback trigger signal output terminal.
I Audio MUTE signal input terminal from DAC.
Compulsion backlight lighting control terminal. (H : lighting, L : ususally)
I
(for design verification)
O IC RESET signal output terminal for force feedback.
- Power supply terminal. (P170-P176)
O Motor drive voltage control signal output terminal.
O Motor control-1 terminal.
- GND connect terminal.
O Motor control-2 terminal.
- No connect terminal.
I Touch Panel signal terminal.
- 65 -
IVA-D310R/IVA-D310RB
Terminal Description
TO SCHEMATIC
TO CONTENTS