Special Wash Cycles And Options - Whirlpool ADP 201 Operating Instructions Manual

Notes:
Optimum performance levels when using the "Rapid" cycles
can be achieved by respecting the specified number of place
settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
contact@whirlpool.com
Wash options
If an option is not compatible with the selected wash cycle
(see table of wash cycles), the corresponding LED flashes
rapidly 3 times and beeps will sound.
Delayed start
It is possible to delay the start time of the wash cycle
by 2, 4 or 8 hours:
1. After selecting the desired wash cycle and any other
options, press the DELAYED START button. The indicator
light will go on.
2. Select the desired delay time by pressing the Delayed Start
button repeatedly. The 2 hours
lights will go on in succession.
If the Delayed Start button is pressed again, the option is
deselected and the indicator light goes off.
3. After the selection process, the countdown will begin if
the Start/Pause button is pressed. The selected delay-period
indicator light is lit and the Start/Pause button lights up (fixed
light).
4. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
To deselect the DELAYED START option, press the START/
PAUSE button
.
The Start Delay function cannot be set once a wash cycle
has started.
, 4 hours and 8 hours indicator
Tablet option (Tab)
This option optimises washing and drying results.
When using Tablet, press the TABLET button; the corresponding
symbol will light up. If the button is pressed again, the option will
be deselected.
The "Tablet" option results in a longer wash cycle.
Half Load option
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity and
detergent. Select the wash cycle and press the HALF LOAD
button: the indicator light will illuminate.
Press the HALF LOAD button to deselect this option.
Remember to halve the amount of detergent.
Drain out
To stop and cancel the active cycle, the Drain Out
function can be used.
A long press of START/PAUSE button, will activate the DRAIN
OUT function. The active cycle will be stopped and the water in
the dishwasher will be drained out.
EN
25