Table of Contents
Advertisement
Lock Options
Enter Code
Lock Options
New Code
6. Press the SELECT button.
7. Confirm the new code using buttons 0-9 and
press the SELECT button.
8. The lock code is now changed.
Antenna Aiming (Home Installation)
Upon entering this mode, two 7-segment vertical bar
graphs are displayed representing terrestrial (tower) and
satellite transmitters. The
signal strength is displayed
by the respective graph
segments. Position the
antenna to optimize either
the satellite or terrestrial signal.
The current setting is indicated by number of bars in the
Lock Options
graph. Moving the antenna location should maximize the num-
Enter Code
ber of bars in the respective graph, thus ensuring optimum
reception. To exit this function, press the SELECT Button.
* * * *
NOTE: Terrestrial repeaters are typically used in large
Lock Options
New Code
* * * *
Channel Add/Skip
Upon entering this mode, a channel list is displayed with the
current channel in play highlighted. Use the Channel Up/Down
buttons to navigate the list and highlight the channel to be
adjusted.
Antenna Aiming
-18-
urban areas where structures may affect the line
of sight satellite signal. Terrestrial signals
may not be available in your geographic location.
Channel Add/Skip
4 The 40s
5 The 50s
6 The 60s
7 The 70s
Channel Add/Skip
4 The 40s
5 The 50s
6 The 60s
7 The 70s
Channel Add/Skip
4 The 40s
5 The 50s
6 The 60s
7 The 70s
Advertisement
Table of Contents
