Clear Voice - Yamaha ats-1010 Owner's Manual

TV remote control operation may be difficult if the unit
hides the sensor of your TV when beneath or under the
TV. Try the two solutions below and see whether this
solves the problem.
@
Move the unit in all directions.
@ Remove the stands to lower the height of
the unit.
Keep the stands and screws in a safe place for future use.
_ sing TV remote control relay function
If you cannot solve the problem by the suggestions abo_,c,
follow the procedure below and use the TV remote
control relay l'unction, which relays the TV remote
control signal received at the front of the unit to the
remote control sensor of your TV through the TV remote
control signal transmitter at the rear of the unit.
The remote
control sensor of
your TV
I TV remote control signal transmitter L/_ 1
1 Set the unit to standby mode.
2
Press both the VOLUME + button and _)
button of the main unit, release the
button first, then release the VOLUME +
button.
The unit is turned on when switching the TV remote
control relay l'unction on/off.
The CLEAR VOICE indicator lights up as the
following illustration. Check if the setting is correct.
(_, P. 11 )
! !!i!: !i!!!
The (?LEAR
VOICE indicator
CLEAR VOICE CLEARVOiCE
(for 2 seconds [] _ [],_
after tile tlnit iS * I _
turned on) No light Green
• The default setting is off.
• You can verify the current setting by turning the
unit on again from standby mode.
• Move tlle unit in all directions again ifTV remote control
remains difficult.
• The TV remote control relay ffmction is enabled even if
tlle unit is in standby mode.
You can use the TV remote control solely to operate by
having the unit learn the TV remote control operations.
You can operate the following functions by TV remote
control.
• Volume down
• Volume up
• Power on/standby mode
Some TV remote controls may not control these functions.
Use the remote control supplied with the unit in this case.
1
Set the unit and TV to standby mode.
2
Press both the INPUT button and _)
button of the main unit, release the (_
button first, then release the INPUT
button.
The unit enters the remote control
iNPUT
learning mode. %=.,
Flashes in
red
Continued to the next page. ,,*
9 En