Table of Contents
Advertisement
SYST:COMM:SER:FDUP?
1
A value of 1 is returned if serial port echo (duplex) is ON. A value of 0 is returned if
serial port echo (duplex) is OFF. Specifying the MIN parameter returns a value of 0.
Specifying the MAX parameter returns a value of 1. Specifying the DEF parameter
returns a value of 1.
7.4.9.4
SYSTem:COMMunicate:SERial:FDUPlex <bool>|MIN|MAX|DEF
Sets the serial port echo (duplex) setting.
SYST:COMM:SER:FDUP MAX
The <bool> parameter turns serial port echo (duplex) mode on (1 or ON) or off (0 or
OFF). Specifying the MIN, MAX, or DEF parameter sets the serial port echo (duplex)
to the minimum, maximum, or default respectively.
7.4.9.5
SYSTem:COMMunicate:SERial:FEED? [MIN|MAX|DEF]
Returns the state of the serial port printing.
SYST:COMM:SER:FEED?
0
A value of 1 is returned if serial port printing is enabled. A value of 0 if returned is
serial port printing is disabled. Specifying the MIN parameter returns a value of 0.
Specifying the MAX parameter returns a value of 1. Specifying the DEF parameter
returns a value of 0.
7.4.9.6
SYSTem:COMMunicate:SERial:FEED <bool>|MIN|MAX|DEF
Sets the state of the serial port printing.
SYST:COMM:SER:FEED DEF
The <bool> parameter turns serial printing on (1 or ON) or off (0 or OFF). Specifying
the MIN, MAX, or DEF parameter sets the serial port printing value to the minimum,
maximum, or default respectively. The *RST command sets the serial port printing to
OFF.
7.4.9.7
SYSTem:COMMunicate:SERial:LINefeed? [MIN|MAX|DEF]
Returns the state of the serial port linefeed setting.
SYST:COMM:SER:LIN?
1
Digital Communications Interface
Commands
103
Advertisement
Table of Contents
